COLD REVEALS. CAVITIES. THERMAL BRIDGING.

Cold reveals and thermal bridging

Mould round windows and in corners has a cause, and it can be measured.

Thermal imaging, surface temperature factor (fRsi) testing and endoscope cavity inspection.

The tests

Each one answers a different question about the wall.

Log the conditions

Temperature and humidity, inside and out, recorded at the time of test.

Find the cold bridge

Thermal imaging shows where heat is escaping and where mould will grow.

Look inside the cavity

An endoscope shows insulation, closers and wall ties without opening up.

Measure the moisture

Carbide tests on drilled samples tell a wet wall from a cold one.

The fRsi test

Surface temperature, measured against the air inside and out, gives a temperature factor, assessed to BS EN ISO 13788. If it falls below the design limit, the building is part of the problem, not just how the home is lived in.

For warranty claims and disputes >

Clear about the limits

Thermal imaging needs a temperature difference between inside and out.

I’ll say if conditions on the day aren’t good enough, and come back when they are.

Instructions and enquiries