Damp blamed on the new driveway: the leak under the kitchen floor

Building: 1980s link-detached house
Location: Milton Keynes
Client: Homeowners

The problem

Damp staining, mould and wet carpet had appeared around the kitchen and dining room over six months. A new driveway had gone in shortly before, built up close to the damp-proof course with the ground sloping towards the house. It was the obvious suspect.

What I found

  • Moisture mapping of the floor: the screed was wettest under the kitchen sink and got steadily drier the further away you went. That is the pattern of water spreading from one point, not coming in from outside.
  • Wall readings: high at skirting level, close to zero 500mm up. The water was coming from the floor, not rising up the walls.
  • Air and surface temperatures: every surface was well above dew point, so this wasn't condensation.
  • Thermal imaging, before and after running the hot tap: a cold, wet zone under the units beforehand, then a concentrated hot spot in the floor under the sink once the hot water ran.
  • Endoscope: corroded copper pipework where it entered the floor, with the screed around it waterlogged.

The cause

A plumbing leak, not the driveway. Water from the corroded copper pipework had been soaking into the kitchen screed and spreading under the floor into the dining room. The ground levels outside were worth correcting, but they weren't causing this.

Outcome

A plumber opened up at the point the thermal imaging found and confirmed a leak in the copper pipework. With the leak repaired, the floor can be dried out and the damp dealt with at source, instead of money going into drainage work that wouldn't have fixed it.

Tests used: floor moisture mapping, thermal imaging, endoscope inspection, hygrometry.

Next
Next

Mould blamed on condensation: the water under the floor